Ricoh 5100WD Operating Instructions Manual page 108

4. Printing GL/2 and TIFF Files
SP Command
Specify whether to eject paper at receipt of "SP;" and "SP0;" command.
Transparency Mode
Specify the transparent processing mode by MC command and TR command.
• Always Active
Always activates MC/TR commands in HP-GL2 data come into effect.
• Use File Defaults
Follows MC/TR commands in HP-GL2 data.
• Always Inactive
4 Ignores MC/TR commands in HP-GL2 data forcibly.
Source Transparency Mode
Specify the transparent processing method by "Source Transparency Mode (ESC*v#N)".
• Always Active
Always activates ESC*v#N commands in RTL data come into effect.
• Use File Defaults
Follows ESC*v#N commands in RTL data.
• Always Inactive
Ignores ESC*v#N commands in RTL data forcibly.
Adjust X Offset
Specify X-axis offset for origin of the drawing area in 1 mm (0.10 ") increments within the range
between -199 and 199 mm (-8 and 8 ").
Adjust Y Offset
Specify Y-axis offset for origin of the drawing area in 1 mm (0.10 ") increments within the range
between -199 and 199 mm (-8 and 8 ").
Brightness
Adjust brightness for RGB-color and grayscale image data. Higher brightness value lightens the entire
image while lower brightness value darkens the image.
Pen Width
Select whether to use file defaults settings, or to specify width for each pen.
Pen Density
Select whether to use file defaults settings, or to specify density for each pen.
Pen 0 Custom Settings - Pen 15 Custom Settings
Specify width and/or density for each pen when the "Use File Defaults" option is selected. Pen Width
can be selected from the list of 0.00 - 12.00 mm, however actual width of printed image could be
106