Toshiba Tosvert VF-S15 Instruction Manual page 279

Item displayed
Output frequency
Direction of
rotation
Frequency
Note 1
command value *
Note 2 Output current
Note 2 Input voltage
Note 3
Note 2
Output voltage
Note 4
Input terminal
Note 5
Output terminal
Cumulative
Note 9
operation time
Past trip 1
*The monitor value of a trip is not always recorded as the maximum value because of the time required for
detection.
Refer to page H-8 and 9 for notes.
Panel
LED display
operated
6








MODE 
H-5
Description
The output frequency when the trip occurred is
displayed.
The direction of rotation when the trip occurred is
displayed.
(: Forward run, : Reverse run)
The frequency command value when the trip occurred is
displayed.
The inverter output current when the trip occurred is
displayed. (%/A)
The inverter input voltage (DC detection) when the trip
occurred is displayed. (%/V).
The inverter output voltage when the trip occurred is
displayed. (%/V)
The ON/OFF status of each of the control signal input
terminals (F, R, RES, S1, S2, S3, VIB, VIA) are
displayed in bits.
ON:  }}i}}i}i
OFF: 
VIA
VIB
S3
S2
The ON/OFF status of each of the control signal output
terminals (RY-RC, OUT, FL) are displayed in bits.
ON: 
0
OFF: 
FL
The cumulative operation time when the trip occurred is
displayed.
(0.10=10 hours, 1.00=100 hours)
Press this key to return to past trip 1.
E6582175
F
R
RES
S1
8
}ii
RY-RC
OUT