Pid Control - Toshiba Tosvert VF-S15 Instruction Manual

Output frequency [Hz]


f351 (Momentary acceleration (deceleration) suspend time) = (t1 + t2 + ts)
 Stall control
The inverter will automatically change the operation frequency when it detects an overcurrent, overload or
overvoltage. Configure each stall control setting using the following parameters.
Overcurrent stall :  (Stall prevention level 1)
Overload stall :  (Electronic thermal protection characteristic selection)
Overvoltage stall :  (Overvoltage limit operation)
Note: When the frequency command value, the acceleration suspend frequency (f350), and the deceleration
suspend frequency (f352) have the same setting, the acceleration/ deceleration suspend function will not
work.

6.24 PID control

fpid : Set value of PID control
f167 : PID set value agreement
detection range
f359 : PID control waiting time
f360 : PID control
f361 : Delay filter
f362 : Proportional gain
f363 : Integral gain
f366 : Differential gain
t1 ts t2
Stall
f367 : Upper limit of set value
f368 : Lower limit of set value
f369 : PID control feedback signal
selection
f372 : Process increasing rate
(speed type PID control)
f373 : Process decreasing rate
(speed type PID control)
f380 : PID forward/reverse
characteristics selection
f389 : PID set value signal selection
F-81
E6582175
Time [s]

6