Subaru LEGACY Service Manual page 39

7) Connect the Subaru Select Monitor to data link
connector located in the lower portion of the instru-
ment panel (on the driver's side).
CAUTION:
Do not connect the scan tools except for Suba-
ru Select Monitor or OBD-II general scan tool.
8) Turn the ignition switch to ON (engine OFF) and
turn Subaru Select Monitor switch to ON.
(A) Power switch
9) On the «Main Menu» display screen, select the
{Each System Check} and press the [YES] key.
10) On the «System Selection Menu» display
screen, select the {Engine} and press the [YES]
key.
11) Press the [YES] key after the information of en-
gine type has been displayed.
12) On the «Engine Diagnosis» screen, select the
{D Check} and press the [YES] key.
13) When the "Perform D Check?" is shown on the
screen, press the [YES] key.
14) Perform subsequent procedures as instructed
on the display screen.
• If trouble still remains in the memory, the corre-
sponding DTC appears on the display screen.
NOTE:
• For detailed operation procedure, refer to "SUB-
ARU SELECT MONITOR OPERATION MANUAL".
• For the details concerning DTCs, refer to "List of
Diagnostic Trouble Code (DTC)".
<Ref. to EN(H4SO 2.5)(diag)-70, List of Diagnostic
Trouble Code (DTC).>
• Release the parking brake.
Inspection Mode
• The speed difference between front and rear
wheels may light the ABS warning light, but this in-
dicates no malfunctions. When engine control diag-
nosis is finished, perform the ABS memory clear
procedure of self-diagnosis function.
3. OBD-II GENERAL SCAN TOOL
1) After performing the diagnostics and clearing
memory, check for any remaining unresolved trou-
ble data: <Ref. to EN(H4SO 2.5)(diag)-41, Clear
Memory Mode.>
2) Warm up the engine.
3) Connect the test mode connector (A) at the low-
er side of globe box.
EN-02533
(A)
4) Connect the OBD-II general scan tool to its data
link connector in the lower portion of instrument
panel (on the driver's side).
CAUTION:
EN-00040
Do not connect the scan tools except for Suba-
ru Select Monitor or OBD-II general scan tool.
5) Start the engine.
NOTE:
• Ensure the select lever is placed in "P" range be-
fore starting. (AT model)
• Depress the clutch pedal when starting engine.
(MT model)
6) Using the select lever or shift lever, turn the "P"
position switch and "N" position switch to ON.
7) Depress the brake pedal to turn brake switch
ON. (AT model)
8) Keep the engine speed in 2,500 — 3,000 rpm
range for 40 seconds.
EN(H4SO 2.5)(diag)-37
ENGINE (DIAGNOSTICS)
(A)
EN-02424
EN-02533