Led Operation Mode For Engine - Subaru LEGACY Service Manual

7. LED OPERATION MODE FOR ENGINE

1) On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
2) On the «System Selection Menu» display screen, select the {Engine} and press the [YES] key.
3) Press the [YES] key after the information of engine type has been displayed.
4) On the «Engine Diagnosis» display screen, select the {Current Data Display/Save}, and then press the
[YES] key.
5) On the «Data Display Menu» display screen, select the {Data & LED Display} and press the [YES] key.
6) Using the scroll key, scroll the display screen up or down until the desired data is shown.
• A list of the support data is shown in the following table.
Remarks
AT/MT identification signal
Test mode signal
Clear memory signal
Neutral position switch signal
Idle switch signal
Ignition switch signal
Power steering switch signal
Air conditioning switch signal
Handle switch signal
Starter switch signal
Rear oxygen sensor rich sig-
nal
Knocking signal
Crankshaft position sensor
signal
Camshaft position sensor sig-
nal
Rear defogger switch signal
Blower fan switch signal
Light switch signal
Small light switch signal
Windshield wiper switch signal Wiper SW
A/C middle pressure switch
signal
Air conditioning relay signal
Radiator fan relay 1 signal
Radiator fan relay 2 signal
Fuel pump relay signal
Tumble generator valve output
signal
Subaru Select Monitor
Display
AT Vehicle ID Signal
Test Mode Signal
Clear Memory Terminal
Neutral Position Switch
Idle Switch Signal
Ignition Switch
P/S Switch
A/C Switch
Handle SW
Starter Switch
Rear O2 Rich Signal
Knocking Signal
Crankshaft Position Signal
Camshaft Position Signal
Rear Defogger Switch
Blower Fan Switch
Light Switch
Light Switch
A/C Mid Pressure Switch
A/C Compressor Signal
Radiator Fan Relay #1
Radiator Fan Relay #2
Fuel Pump Relay
TGV Output
EN(H4SO 2.5)(diag)-31
Message
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
RHD or LHD
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ENGINE (DIAGNOSTICS)
LED "ON" requirements
Illuminate (AT model)
D check
When clear memory connec-
tor is connected.
When neutral position signal is
entered.
When idle switch signal is
entered.
When ignition switch is turned
to ON.
When power steering switch is
entered.
When air conditioning switch is
input.
When handle switch signal is
input.
When starter switch is input.
When rear oxygen sensor mix-
ture ratio is rich.
When knocking signal is input.
When crankshaft position sen-
sor signal is input.
When camshaft position sen-
sor signal is entered.
When rear defogger switch is
turned to ON.
When blower fan switch is
turned to ON.
When light switch is turned to
ON.
When small light switch is
turned to ON.
When windshield wiper switch
is turned to ON.
When A/C middle pressure
switch is turned to ON.
When air conditioning relay is
in function.
When radiator fan relay 1 is in
function.
When radiator fan relay 2 is in
function.
ON output
Yes