Specifying The Independent Analyzer Clock Source; Independent Timing Analyzer - HP 64700 User Manual

Specifying the
Independent
Analyzer Clock
Source
Independent
Timing Analyzer
Note
The clock source for the independent state analyzer is specified with
the xtck (external trace clock) command. The independent state ana-
lyzer may be clocked with target system clock signals connected to the
JCL and KCL external clock inputs. (Refer to the "Selecting Clock Sig-
nals" section of the "Special Analyzer Topics" chapter).
Independent Analyzer Slave Clocks
You can specify slave clocks for the external analyzer with the xtsck (ex-
ternal trace slave clock) command. Specifying slave clocks is the same
for the external analyzer as it is for the emulation analyzer; refer to the
"Using Slave Clocks for Demultiplexing" section of the "Special Ana-
lyzer Topics" chapter.
When xtmo -t is specified, the external analyzer operates as an inde-
pendent timing analyzer.
The external analyzer's independent timing mode cannot be used
from the Terminal Interface. A host computer interface is necessary
to provide timing analysis. Consequently, independent timing analysis
is not described in this manual. Refer to the appropriate host com-
puter interface analyzer manual (either the PC Interface: Analyzer
User's Guide or the Softkey Interface: Analyzer User's Guide).
Using the External Analyzer 4-11