Table of Contents
Advertisement
Load the Program
Run the Program
R>r 400
U>
The Default Trace
Specification
Initializing the
Analyzer (tinit)
U>tinit
Getting Started 2-6
Absolute files, in a number of different file formats, can be loaded into
an HP 64700 Series emulator in a number of different ways. Refer to
the Terminal Interface: Emulator User's Guide for information on load-
ing programs into the emulator.
To start the emulator executing the example you would enter the run
command below.
The address 400H is the start address of the sample program and the
"U> " prompt shows that the emulator is executing the "user" sample
program.
After the emulator is powered-up or initialized, the analyzer is in its
simplest configuration. The default condition will trigger on any state,
and store all captured states. You can simply issue a trace command (t)
to trace the states currently executing.
To be sure that the analyzer is in its default or power-up state, or to re-
set the analyzer to its default state, you can enter the tinit (trace initiali-
zation) command.
Advertisement
Table of Contents
