Rinnai RB-27F Instruction Manual page 11

Not using built in hob for a long time
1. Please block gas pipe (such as entrance to pipe connector) to prevent blockage
caused by foreign matter.
2. Clear away all residues, and cover with plastic bag to prevent dust and foreign
matter from entering.
3. Pack into box and store in a dry location.
If product is dismantled, please reassemble cor rectly
after maintenance.
8. Easy repair
*If failure occurs, please refer to easy repair chart.
If problem can not be solved, please contact our ser vice center
immediately.
Problem
Cause
Gas not turned on or
insufficient gas
LPG almost used up
Air in rubber piping
Too low
Inappropriate gas
pressure
Too high
Rubber piping bent
Electrode dirty
Fire vent or air vent blocked
Burner head and pan support
installed incorrectly
Ignition operation incorrect
Air regulation incorrect
Switch knob stuck
Ignition high tension cable
not connected
Incorrect gas type
Inappropriate ignition
operation
Ignition device failure
Safety device
(thermocouple) actuation
Safety device
(thermocouple) failure
Remedy
Turn off stove,then open gas
tank
Replace gas tank
Repeat ignition until
successful
Adjust gas pressure
Straighten piping
Wipe clean with dry cloth,
clear away residue (or wipe
off water drops)
Install Correctly
Operate correctly
Adjust air amount correctly
Check and adjust
Connect high tension cord
to electrode
Check and amend
See "ignition operation" or
press longer on swith knob
Check and fix/replace