Aspect Controls - Panasonic TH-42PH10EK Operating Instructions Manual

ASPECT Controls

The Plasma Display will allow you to enjoy viewing the picture at its maximum size, including wide screen cinema
format picture.
[from the unit]
+
INPUT MENU -/ VOL / ENTER/
[During MULTI PIP Operations]
• Picture and Picture, Picture in Picture :
• Others
Notes:
• For PC signal input, the mode switches between "4:3", "Zoom" and "16:9" only.
• For a 1125 (1080) / 60i · 50i · 24p · 25p · 30p · 24sF, 1250 (1080) / 50i, 750 (720) / 60p · 50p signal input, the mode
is set to "16:9" mode, and switching is not possible.
• Panasonic Auto can be selected only during Video signal input.
• The aspect mode is memorized separately for each input terminal.
Mode
4
4 : 3
4
Zoom
4
16 : 9
4
Just
4
For an elongated image
Panasonic
4
Auto
For a 4:3 image
Note:
Do not allow the picture to be displayed in 4:3 mode for an extended period, as this can cause a permanent image retention
to remain on the Plasma Display Panel.
18
Press repeatedly to move through the aspect options:
Note:
When selecting an input slot that attaches BNC Dual Video Terminal
Board (TY-FB9BD), Panasonic Auto cannot be selected.
The aspect mode changes each time the ENTER button is
pressed.
: Aspect switching is not possible.
Picture
4 : 3
3
16
3
16
3
16
3
16
Panasonic Auto
3
Image is expanded
Changes in
accordance with
the Panasonic Auto
3
mode setting (see
page 39).
4 : 3 Zoom 16 : 9
Panasonic Auto
4 : 3 16 : 9
4:3 will display a 4:3 picture at its standard 4:3 size.
Zoom mode magnifi es the central section of the picture.
Zoom
9
16:9 will display the picture at its maximum size but with slight
elongation.
16 : 9
9
Just mode will display a 4:3 picture at its maximum size but with
Just aspect correction applied to the center of the screen so that
elongation is only apparent at the left and right edges of the screen.
9
The size of the picture will depend on the original signal.
The display will automatically become enlarged (depending on the
picture source), allowing you to view the picture at its maximum
size.
9
Notes:
• Panasonic Auto mode is designed to automatically adjust the
aspect ratio to handle a mix of 16:9 and 4:3 program material.
Certain 4:3 program material, such as stock market data screens,
may occasionally cause the image size to change unexpectedly.
When viewing such programs, it is recommended that the ASPECT
be set to 4:3.
• If adjusting the Picture V-Pos/V-Size in Panasonic Auto with 16:9
mode, the adjustment is not memorized. When exiting the mode,
the screen will return to a former adjustment.
• Panasonic Auto can not be selected while BNC Dual Video
Terminal Board (TY-FB9BD) is installed.
Just
Explanation