Color System / Panasonic Auto; 3:2 Pulldown / Video Nr - Panasonic TH-50PH10UKA Operating Instructions Manual

COLOR SYSTEM / Panasonic AUTO

Select SIGNAL from the "SET UP" menu during VIDEO (S VIDEO) input
signal mode.("SIGNAL [VIDEO]" menu is displayed.)
Mode
COLOR SYSTEM
Panasonic AUTO
(4 : 3 )
Note:
Panasonic AUTO does not function when BNC Dual Video Terminal Board (TY-FB9BD) is used.

3:2 PULLDOWN / VIDEO NR

3:2 PULLDOWN: When ON, the display attempts to reproduce a more natural interpretation of sources such as movie
pictures, which are recorded at 24 frames per second.
If the picture is not stable, turn the setting to OFF.
Notes:
When ON, this setting only affects the following signal input:
• NTSC / PAL signal input during "VIDEO (S VIDEO)" input signal.
• 525i(480i), 625i(575i), 1125(1080)/60i signal input during "COMPONENT" input signal.
VIDEO NR: Automatically reduces unwanted picture noise.
Note:
VIDEO NR cannot be adjusted while a PC signal is being applied.
1
2
Press to select the "COLOR SYSTEM" or "Panasonic
AUTO".
Press to select each function.
If the image becomes unstable:
With the system set on Auto, under conditions of low
level or noisy input signals the image may in rare
cases become unstable. Should this occur, set the
system to match the format of the input signal.
Set the color system to match the input signal. When selecting "AUTO", the color system is automatically
selected from NTSC/PAL/SECAM, however, M.NTSC signal is not displayed properly depending on
the attached terminal board. To display M.NTSC signal, select "M.NTSC" in COLOR SYSTEM.
AUTO
Set to "NORMAL" to view 4:3 images in an unchanged format when Panasonic AUTO is
selected. If you would like to view 4:3 images in Just format, set to "JUST".
Press to select 3:2
PULLDOWN or VIDEO NR.
Press to set ON/OFF.
Press to exit from adjust mode.
SET UP for Input Signals
Function
PAL SECAM M.NTSC
SIGNAL
3D Y/C FILTER (NTSC)
COLOR SYSTEM
3 : 2 PULLDOWN
Panasonic AUTO (4 : 3) NORMAL
VIDEO NR
[ COMPONENT ]
SIGNAL
3 : 2 PULLDOWN
VIDEO NR
SET UP
SIGNAL
COMPONENT/RGB-IN SELECT
INPUT LABEL
POWER SAVE
STANDBY SAVE
POWER MANAGEMENT
AUTO POWER OFF
ENGLISH ( US )
OSD LANGUAGE
Press ACTION ( ) button
SIGNAL
3D Y/C FILTER (NTSC)
COLOR SYSTEM
3 : 2 PULLDOWN
Panasonic AUTO (4 : 3) NORMAL
VIDEO NR
NTSC
SET UP
SIGNAL
COMPONENT/RGB-IN SELECT
INPUT LABEL
POWER SAVE
STANDBY SAVE
POWER MANAGEMENT
AUTO POWER OFF
ENGLISH ( US )
OSD LANGUAGE
Press ACTION ( ) button
[ VIDEO ]
SIGNAL
ON SYNC
AUTO 3 : 2 PULLDOWN
OFF
VIDEO NR
H-FREQ. 33.8
OFF
V-FREQ. 60.0
SIGNAL
OFF 3 : 2 PULLDOWN
OFF VIDEO NR
H-FREQ. 33.8
V-FREQ. 60.0
1/2
RGB
PC
OFF
OFF
OFF
OFF
[ VIDEO ]
ON
AUTO
OFF
OFF
1/2
RGB
PC
OFF
OFF
OFF
OFF
[ RGB ]
AUTO
OFF
OFF
kHz
Hz
[ Digital ]
OFF
OFF
kHz
Hz
37