Color System / Panasonic Auto; 3:2 Pulldown; Xga Mode - Panasonic TH-103PF12T Operating Instructions Manual

COLOR SYSTEM / Panasonic AUTO

Select SIGNAL from the "SET UP" menu during VIDEO (S VIDEO) input signal mode.
("SIGNAL [VIDEO]" menu is displayed.)
Mode
COLOR SYSTEM Set the color system to match the input signal. When selecting "AUTO", the color system is automatically
Panasonic AUTO
(4 : 3 )
Note:
Panasonic AUTO does not function when BNC Dual Video Terminal Board (TY-FB9BD) is used.

3:2 PULLDOWN

3:2 PULLDOWN: When ON, the display attempts to reproduce a more natural interpretation of sources such as movie
pictures, which are recorded at 24 frames per second.
If the picture is not stable, turn the setting to OFF.
Note:
When ON, this setting only affects the following signal input:
• NTSC / PAL signal input during "VIDEO (S VIDEO)" input signal.
• 525i(480i), 625i(575i), 1125(1080)/60i signal input during "COMPONENT" input signal.

XGA MODE

This menu is displayed when the input signal is analog (Component/PC).
This unit supports three types of XGA signals with 60Hz vertical frequency having different aspect ratios and sampling
rates (1,024 × 768 @ 60Hz, 1,280 × 768 @ 60Hz and 1,366 × 768 @ 60Hz).
Note:
After making this setting, be sure to make each adjustment (such as "AUTO SETUP") on the "POS. /SIZE" menu as
necessary. (see page 24)
Press to select the "COLOR SYSTEM" or
"Panasonic AUTO (4:3)".
Press to select each function.
If the image becomes unstable:
With the system set on Auto, under conditions of low level or noisy
input signals the image may in rare cases become unstable. Should
this occur, set the system to match the format of the input signal.
selected from NTSC/PAL/SECAM, however, M.NTSC signal is not displayed properly depending on
the attached terminal board. To display M.NTSC signal, select "M.NTSC" in COLOR SYSTEM.
To display PAL60 signal, select "PAL" when BNC Dual Video Terminal Board (TY-FB9BD) is
used. For other Video Terminal Boards, select "M.NTSC".
AUTO
Set to "4:3" to view 4:3 images in an unchanged format when Panasonic AUTO is selected.
If you would like to view 4:3 images in Just format, set to "JUST".
Press to select "3:2 PULLDOWN".
Press to set ON/OFF.
Press to select "XGA MODE".
Press to select "AUTO", "1024×768", "1280×768", "1366×768".
AUTO: Automatically selected from 1024×768/1280×768/1366×768.
Switch the setting to suit the input signal for better display depends on the angle of view
or display resolution condition.
SET UP for Input Signals
Function
PAL SECAM
SIGNAL
3D Y/C FILTER (NTSC)
COLOR SYSTEM
3 : 2 PULLDOWN
Panasonic AUTO (4 : 3)
M.NTSC NTSC
3 : 2 PULLDOWN
XGA MODE
[ VIDEO ]
ON
AUTO
OFF
4:3
OFF
AUTO
51