Panasonic TH-50PH10UKA Operating Instructions Manual page 41

Item Effect
Off-timer
function
Enable Disable
Initial Power
Mode
ID select
Remote ID
Off On
Serial ID
Off On
Display size
Off On
Studio W/B
Off On
Studio Gain
Off On
Enable: Enables the "Off-timer function".
Disable: Disables the "Off-timer function".
Note: When "Disable" is set, the Off-timer is cancelled.
Normal Standby
Sets the power mode of the unit for when the power recovers from failure or after plugging off and in again.
Normal: Power returns in as the same state as before the power interruption.
Standby: Power returns in standby mode. (Power Indicator : red/orange)
On: Power returns in power On. (Power Indicator : green)
Note: When using multiple displays, "Standby" is preferred to be set in order to reduce a power load.
Sets panel ID number when panel is used in "Remote ID" or "Serial ID".
Set value range: 0 - 100
(Standard value: 0)
Off: Disables ID remote control functions. You can use normal remote control operations.
On: Enable ID remote control functions.
Sets the panel ID Control.
Off: Disables external control by the ID.
On: Enables the external control by the ID.
Adjusts the image display size on screen.
Off: Sets the normal image display size on screen.
On: Sets the image display size approximately 95 % of the normal image display.
Off
Notes:
• This setting is valid only when the input signals are as follows;
NTSC, PAL, SECAM, M.NTSC, PAL60, PAL-M, PAL-N (BNC Dual Video Terminal Board (TY-FB9BD))
525i, 525p, 625i, 625p, 750/60p, 750/50p, 1125/60i, 1125/50i, 1125/24sF, 1125/25p, 1125/24p,
1125/30p, 1250/50i (Component Video, RGB, DVI, SDI, HDMI)
• This setting is invalid when two screen display, digital zoom or Multi screen is selected.
• When "Display size" is set to "On", "POS. /SIZE" adjustment cannot be used.
• Refer to each board's operating instruction for DVI, SDI, HDMI's corresponding signals.
Off: Nullify all the settings adjusted.
On: Sets the color temperature for TV studio.
Note: Valid only when the low is set as color temperature on screen adjustment.
Sharpens the contrast for a better view when a part of the image is too light to see.
Off: Disables "Studio Gain".
On: Enables "Studio Gain".
Note: This setting is valid only when the input signals are as follows:
Component Video, RGB (analog), SDI, HDMI
Adjustments
On
On
Options Adjustments
Options
Off-timer function
Initial Power Mode
ID select
Remote ID
Serial ID
Display size
Studio W/B
Studio Gain
2/3
Enable
Normal
0
Off
Off
Off
Off
Off
41