Opel MOVANO Owner's Manual page 208

206 Vehicle care
9. Connect the red < power supply
lead on the compressor to the
jump start terminal 3 213.
Note
Depending on model, the jump start
terminal may be located at the left-
hand or right-hand side of the engine
compartment.
10. Connect the black ] power
supply lead to a vehicle grounding
point, e.g. the engine block or an
engine mounting bolt.
Note
Depending on tyre repair kit type, it
may be necessary to connect the
single power supply lead to the
power outlet or cigarette lighter
socket.
For this type, the red < and
black ] power supply leads will not
be present.
To avoid discharging the battery,
we recommend running the
engine.
11. Set the rocker switch on the
compressor to position I. The tyre
is filled with sealant.
12. The compressor pressure gauge
briefly indicates up to six bar.
Then the pressure starts to drop.
13. All of the sealant is pumped into
the tyre. Then the tyre is inflated.
14. The prescribed tyre pressure
should be obtained within
ten minutes. Tyre pressure
3 246. When the correct pressure
is obtained, turn off the
compressor by setting rocker
switch to position O.
If the prescribed tyre pressure is
not obtained within ten minutes,
remove the tyre repair kit. Move
the vehicle one tyre rotation
(approx. two metres). Reattach
the tyre repair kit and continue the
filling procedure for ten minutes. If
the prescribed tyre pressure is still
not obtained, the tyre is too badly