Opel COMBO Owner's Manual page 46

44 Seats, restraints
2. Remove the flexible cord and
lower the seat assembly to the
floor, ensuring the rear support is
located on the anchor point and
securely latched into position.
3. Raise the backrest and adjust the
head restraint.
Note
The backrest is properly engaged
when the red mark on the release
lever is no longer visible.
9 Warning
When unfolding the seat, ensure
that the seat assembly is securely
locked in position before driving.
Failure to do so may result in
personal injury in the event of hard
braking or a collision.
9 Warning
Only drive the vehicle if the
backrests are securely locked into
position. Otherwise there is a risk
of personal injury or damage to the
load or vehicle in the event of hard
braking or a collision.
Removing the seats
Depending on version, the load
compartment area can be increased
by removing the third row seats.
9 Warning
Removable rear seats are heavy!
Do not attempt to remove without
assistance.
● Press release buttons and pull
the rear seat head restraints
upwards to remove them 3 35.
● Ensure that the seat belts are
unfastened and that they do not
obstruct the unfolding
manoeuvre.
● Remove the load compartment
cover if necessary 3 63.
1. Fold the seat assembly (refer to
"Folding the seats" above).
2. Push the lower lever to disengage
the locks and remove the seat
assembly from the floor anchor
points.
3. Store head restraints on the rear
of the seat frame.