Identification Plate; Engine Identification - Opel COMBO Owner's Manual

180 Technical data

Identification plate

The identification plate is located in
the engine compartment, attached to
the bulkhead.
Information on identification label:
1 : type approval number
2 : vehicle Identification Number
3 : vehicle type identification
code
4 : permissible gross vehicle
weight rating in kg
5 : permissible gross train weight
in kg
6 : maximum permissible front
axle load in kg
7 : maximum permissible rear
axle load in kg
8 : engine type
9-11 : vehicle-specific or country-
specific data
Note
The identification plate on your
vehicle may differ from the
illustration shown.
The combined total of front and rear
axle loads must not exceed the
permissible gross vehicle weight. For
example, if the front axle is bearing its
maximum permissible load, the rear
axle can only bear a load that is equal
to the gross vehicle weight minus the
front axle load.
The technical data is determined in
accordance with European
Community standards. We reserve
the right to make modifications.
Specifications in the vehicle
documents always have priority over
those given in this manual.

Engine identification

The engine number is stamped on the
engine block.
The technical data tables show the
engine identifier code. Engine data
3 182.
To identify the respective engine,
refer to the engine power in the EEC
Certificate of Conformity provided
with your vehicle or other national
registration documents.