Overrun Cut-Off; Stop-Start System - Opel COMBO Owner's Manual

Hide thumbs Also See for COMBO:
Table of Contents

Advertisement

116
Driving and operating
Control indicator 9 illuminates if the
fuel cut-off switch is triggered and,
depending on version, a
corresponding warning message may
also appear in the Driver Information
Centre 3 90.
Generic warning control indicator 9
3 81.
Note
In addition, the vehicle is
automatically unlocked and the
hazard warning flashers and interior
lights are illuminated.
Turn the ignition key to position 0 to
prevent vehicle battery discharge and
seek the assistance of a workshop
immediately. Have the vehicle
checked for fuel leaks in the engine
compartment, beneath the vehicle
and near the fuel tank.
To reset the fuel cut-off system and
enable the vehicle to be driven:
1. Turn the ignition key to position 1
3 114.
2. Fully actuate the right turn signal
light 3 101.
3. Deactivate the right turn signal
light.
4. Fully actuate the left turn signal
light.
5. Deactivate the left turn signal
light.
6. Repeat steps 2, 3, 4 and 5.
7. Turn the ignition key to position 0.
9 Danger
If you can smell fuel in the vehicle,
or a fuel leak is present, have the
cause of this remedied
immediately by a workshop. Do
not reset the fuel cut-off system, to
avoid the risk of fire.
Fuel system messages 3 96.

Overrun cut-off

The fuel supply is automatically cut-
off during overrun, i.e. when the
vehicle is driven with a gear engaged
but accelerator is released.
Depending on driving conditions, the
overrun cut-off may be deactivated.

Stop-start system

The stop-start system helps to save
fuel and to reduce exhaust emissions.
When conditions allow, it switches off
the engine as soon as the vehicle is
at a low speed or at a standstill, e.g.
at a traffic light or in a traffic jam. It
starts the engine automatically as
soon as the clutch is depressed.
A vehicle battery sensor ensures that
an Autostop is only performed if the
vehicle battery is sufficiently charged
for a restart.
Activation
The stop-start system is available as
soon as the engine is started, the
vehicle starts-off and the conditions
as stated below in this section are
fulfilled.

Advertisement

Table of Contents
loading

Table of Contents