4. Unscrew the four retaining screws
using a screwdriver. Turn bulb
holder for reverse light
anticlockwise and replace bulb.
5. Remove bulb holder and seal
from lamp assembly.
6. Push bulb into socket slightly,
rotate anticlockwise, remove and
renew bulb.
Brake light (1)
Turn signal light (2)
Tail light (3)
Tail light/fog light (4)
7. Install seal on bulb holder
ensuring it is fitted correctly.
Install bulb holder in lamp
assembly ensuring that it
engages correctly. Tighten the
four retaining screws using a
screwdriver.
8. Install reverse light bulb holder
and turn clockwise to tighten.
9. Engage connector plug.
Vehicle care
10. Insert lamp assembly in body,
ensuring correct positioning.
Tighten the three retaining
screws.
11. Switch on ignition, operate and
check all lights.
Side turn signal lights
Have bulbs replaced by a workshop.
Centre high-mounted brake
light
Have bulbs replaced by a workshop.
151