Table of Contents
Advertisement
Specification
Electrical Requirements
Motor Speed
Unpacking
When unpacking, check to make sure that the is
intact and undamaged. If any parts are missing
or broken, please call Harbor Freight Tools at the
Instructions for putting into use
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this manual including all
text under subheadings therein
before set up or use of this product.
ACCIDENTAL OPERATION:
Turn the Power Switch of the tool to
its "OFF" position and unplug the
tool from its electrical outlet before
assembling or making any
adjustments to the tool.
Operating Instructions
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this manual including all
text under subheadings therein
before set up or use of this product.
Tool Set Up
ACCIDENTAL OPERATION:
Turn the Power Switch of the tool to
its "OFF" position and unplug the
tool from its electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
To insert a drill bit, hold the rear ring of the
Chuck (2) with one hand while turning the front
ring with the other. Open the jaws enough to
allow the bit to slide in. Turn the front ring the
Item 98179
120 VAC / 60 Hz /
4.1 A
n
0-1500/min
0
TO PREVENT SERIOUS
INJURY FROM
TO PREVENT SERIOUS
INJURY FROM
For technical questions, please call 1-888-866-5797.
Chuck Size
Chuck Type
number shown on the cover of this manual as
soon as possible.
Note: For additional information regarding the
parts listed in the following pages, refer to
the Assembly Diagram near the end of this
manual.
Functions
1.
This drill is suitable for drilling operations.
2.
The Trigger can be locked in the ON
position for extended operation.
3.
The Keyless Chuck allows the operator to
install and remove drill bits without the use
of a separate key or other tool.
opposite direction to tighten the jaws on the bit.
Be sure the bit is centered in the jaws. Tighten
firmly by hand.
Work Piece and Work Area Set Up
1.
Designate a work area that is clean and
well-lit. The work area must not allow
access by children or pets to prevent injury
and distraction.
2.
Route the power cord along a safe route
to reach the work area without creating
a tripping hazard or exposing the power
cord to possible damage. The power cord
must reach the work area with enough
extra length to allow free movement while
working.
3.
Secure loose work pieces using a vise or
clamps (not included) to prevent movement
while working.
3/8 Inch
Keyless Chuck
Page 7
Advertisement
Table of Contents
