Recording The Results Of Measurement - HEIDENHAIN TNC 620 User Manual

Soft key Cycle
427 MEASURE COORDINATE
(2nd soft-key row) Measuring any
coordinate in a selectable axis
430 MEASURE BOLT HOLE CIRCLE
(2nd soft-key row) Measuring position
and diameter of a bolt hole circle
431 MEASURE PLANE
(2nd soft-key row) Measuring the A
and B axis angles of a plane

Recording the results of measurement

For all cycles in which you automatically measure workpieces (with
the exception of Cycles 0 and 1), you can have the TNC record
the measurement results. In the respective probing cycle you can
define if the TNC is to
Save the measuring log to a file
Interrupt program run and display the measuring log on the
screen
Create no measuring log
If you want to save the measuring log to a file the TNC, by default,
saves the data as an ASCII file. The TNC will save the file in the
directory that also contains the associated NC program.
Use the HEIDENHAIN data transfer software
TNCRemo if you wish to output the measuring log
over the data interface.
HEIDENHAIN | TNC 620 | User's manual for cycle programming | 9/2015
Page
415
418
421
Fundamentals 15.1
15
385