Omron CJ1W-CT021 Operation Manual page 72

Counter Types
Forcing ON/OFF Digital
Outputs
General Setting:
Status Digital Outputs of
Simple Counter
General Setting:
n+14
52
After you have set the Automatic/Manual Selection bit to Manual Output Control
(=1), the two Digital Outputs can be forced ON and OFF using the corresponding
bits in CIO.
15 14 13 12 11 10 9
n
Bits 0 and 1 correspond to the Physical Digital Outputs O0 and O1.
*
Automatic Output Control is available for Circular- and Linear Counters in Range- or
Comparison Mode (refer to 3-5 "Output Control" for more details).
The current status of the two Digital Outputs is reported in CIO.
15 14 13 12 11 10 9
Bits 0 and 1 correspond to the Physical Digital Outputs O0 and O1.
8 7 6 5 4 3 2 1
O1 O0
8 7 6 5 4 3 2 1
O1 O0
0
Manual Output Control:
0 = Force Output OFF
1 = Force Output ON
Selection Automatic*/Manual:
0 = Automatic Output Control
1 = Manual Output Control
0
Digital Output Status:
0 = Output is OFF
1 = Output is ON
Section 3-2