Maintenance And Inspection; Cleaning; Routine Inspections - Omron CJ1W-CT021 Operation Manual

Maintenance and Inspection

5-3

Maintenance and Inspection

5-3-1

Cleaning

!Caution Never use volatile solvents such as paint thinner or benzene or chemical wipes.
5-3-2

Routine Inspections

Inspection Equipment
142
This section describes the routine cleaning and inspection recommended as reg-
ular maintenance.
Clean the High-speed Counter Unit regularly as described below in order to keep
it in its optimal operating condition.
•
Wipe the Unit with a dry, soft cloth for regular cleaning.
•
When a spot cannot be removed with a dry cloth, dampen the cloth with a neu-
tral cleanser, wring out the cloth, and wipe the Unit.
•
A smudge may retain on the Unit from gum, vinyl, or tape that was left on for a
long time. Remove the smudge when cleaning.
These substances could damage the surface of the Unit.
In order for your High-speed Counter Unit to continue operating at optimum con-
dition, periodic inspections are necessary. Be sure to inspect the system periodi-
cally to keep it in its optimal operating condition. In general, inspect the system
once every 6 to 12 months, but inspect more frequently if the system is used with
high temperature or humidity or under dirty / dusty conditions.
Prepare the following equipment before inspecting the system.
Required Equipment:
Have a standard and Phillips-head screwdriver, multimeter, alcohol, and a clean
cloth.
Equipment that could be needed:
Depending on the system conditions, a synchroscope, oscilloscope, thermometer,
gas sensor or hygrometer (to measure humidity) might be needed.
Section 5-3