Lift Motor Calibration; Select Voltage; Motor Max . Speed; Diameter Of The Rollers - Tunturi j6f Service Manual

_____________________________________________________________________________________
1.7.2
If the lift motor is not calibrated, the calibration procedure will be automatically initiated when the
page 2 of the Service Menu is selected. Stages of the calibration:
Cal1 run down
The left hand side display shows the goal position 10 / -2 / 0.
The display in the centre shows the stage (Cal1, Cal2, Done).
The right hand side display shows the pulse counter value. The value will be resetted at the end of
stage Cal1, when position 10 (lower limit switch) is reached. At the end of calibration, the elevator
is driven to horizontal, e.g. position 0. The procedure can be re-initiated by pressing + key.
1.7.3
Select operation voltage 230 or 115 V. the value 230/115 is shown in the display in the centre.
1.7.4
Select motor speed 16/18/20, the display value 16, 18, 20.
1.7.5
Select the roller diameter 58/60 mm, the display value 58/60. The value affects the distance and
speed displays.
The treadmill can use rollers of two different diameters. The 58 mm roller can be recognized by
the bearings at the level of the outer edge of the roller, whereas the 60 mm roller has the bearings
clearly inside the outer edge. The size of the rear roller has no effect on the speed or distance
display. When replacing the front roller, the diameter has to be recognized and the correct
corresponding setting value checked in the meter.
1.7.6
The display in the centre shows the software version in use, e.g. 0.3.
1.7.7
The display in the centre shows ProF. Start the profile by pressing the + key.
Copyright by Tunturi Oy Ltd
SERVICE MANUAL
Page 2 Lift motor calibration
Page 3 Select voltage
Page 4 Motor max. speed
Page 5 Diameter of the rollers
Page 6 SW version
Page 7 Start test profile
TUNTURI
Cal2 run up
7
Version 1/2000
Done ready
All information subject to changes