Dell PowerEdge R330 Owner's Manual page 104

1. Ensure that you follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the Phillips #2 screwdriver ready.
4. Remove the cooling shroud.
Steps
1. Align and insert the tabs on the iDRAC port card into the slots on the chassis.
2. Insert the iDRAC port card into the connector on the system board.
3. Tighten the screw that secures the iDRAC port card holder to the system board.
Figure 67. Installing the iDRAC port card
1. screw
3. iDRAC port card board
5. tabs on the iDRAC port
7. iDRAC port card connector
Next steps
1. Install the cooling shroud.
2. If disconnected, reconnect the network cable.
3. Follow the procedure listed in the After working inside your system section.
Related links
Removing the cooling shroud
Installing the cooling shroud
104
2. iDRAC port
4. SD vFlash media card slot
6. slots on the chassis
8. iDRAC port card holder