Epson PictureMate Pal User Manual page 93

■
The methods for using memory cards vary according to card type. Be sure to refer
to the documentation packaged with your memory card for details.
■
Use only memory cards compatible with the printer. Refer to Compatible
Memory Cards.
■
Place the printer on a flat, stable surface that extends beyond the base of the
printer in all directions. The printer will not operate properly if it is tilted at an
angle. If you place the printer by the wall, leave more than 10 cm (4 inches)
between the back of the printer and the wall.
■
When storing or transporting the printer, do not tilt it, stand it on its side, or turn
it upside down. Otherwise, ink may leak from the cartridge.
■
Leave enough space in front of the printer for the paper to be fully ejected.
■
Avoid places subject to rapid changes in temperature and humidity. Also, keep the
printer and the AC adapter away from direct sunlight, strong light, water, or heat
sources.
Caution: Keep PictureMate Pal out of the sun and don't leave it in your car or
other location where it can get too hot or too cold. Otherwise PictureMate Pal
may be damaged or ink may leak.
■
Avoid places subject to dust, shock, or vibration.
■
Leave enough room around the printer to allow for sufficient ventilation.
■
Place the AC adapter near a wall outlet where the plug can be easily unplugged.
■
Do not place or store the printer or the AC adapter outdoors.
■
Do not block or cover the vents and openings in the printer.
■
Power supply cords should be placed to avoid abrasions, cuts, fraying, crimping,
and kinking. Do not place objects on top of power-supply cords and do not allow
the AC adapter or power-supply cords to be stepped on or run over. Be
particularly careful to keep all power-supply cords straight at the ends and the
points where they enter and leave the AC adapter.
93