THUNDER TIGER mini Titan E325 Manual page 12

Main Rotor-6
No. Material No. Description
1 BV1010A Swashplate
2 HNU2-9Z Shouldered Screw M2x9
3
BK1058 Flybar Control Lever
4
BK1481 Flat Washer d2xD3.7x0.5
5 BK0914 Washout base
6
BK1203 Linkage Ball (Ø3.8)
Step 1
1.Install the Bearings into the Flybar Control Lever.
2.Secure the Washout Linkage to the Flybar Control Lever and make sure that the Washout
Linkage can be rotated freely.
3.Secure the Linkage Balls to the Flybar Control Lever.
The inner hole is for beginner, and the outer hole
is for 3D flying.
4.Secure the Flybar Control Lever to the
Washout Base.
5.Make sure that the Flybar Control
Lever can berotated freely.
Step 2
1.Slide in the Washout Assembly and make
sure the Pins of the Main Rotor Hub can go
through the holes of the Washout Base.
2.Then slide in the Swashplate and attach the
Washout Linkage to the inner Linkage Balls
of the Swashplate.
(1)
Qty No. Material No.
1 7 HSP16-6N
8 BK1020
2
9
2 HME3-3B
10
4 HMV520ZZW
11 HSP17-7N
1
12
2 BK1014
(7)
(6)
(3)
(10) (4)
(2)
Step 3
1.Slide the Main Shaft Lock Ring and fix it
with a Set Screw.
2.Mind the distance from the end of the
Main Shaft to the Lock Ring is about 70mm.
Description
Countersunk Screw M1.6x6
Main Shaft Lock Ring
Set Screw M3x3
Bearing d2xD5x2.5
Countersunk Screw M1.7x7
Washout Linkage
(4)
(5)
For begineer
For 3D flying
(12)
(11)
T22
(9)
(8)
70mm
Bag C
Qty
2
1
1
4
2
2
-11-