JVC LT-26WX84 Service Manual page 26

(3) VIDEO STATUS
ST : STANDARD
DA : DYNAMIC
TH : THEATER
GA : GAME
(4) WHITE BALANCE
H : HIGH
L : LOW
(5) IP CHANGING MODE
FL : FRAME
L1 : LINE
23 : COMPULSORY NATURAL CINEMA IN
(6) MEMORY MODE
MUTE : Press [MUTING] key
DIR : Change data then memory at the same time.
4.5.6 SERVICE MODE SETTING
1. PICTURE/SOUND
AUDIO, VIDEO, DEFLECTION data adjustment.
(1) SETTING ITEM No.
A : AUDIO
S : SIGNAL
D : DEFLECTION
F : FACTORY SETTING
• Press [CH+] / [CH-] key
A01 S01
Item No. is up/down
• Press [SLEEP TIMER] key
A01 S01
Skip change
(2) SETTING ITEM NAME
Describe setting item name
(3) SETTING VALUE
Set the setting value.
• Press [VOL+] / [VOL-] key
Set the setting value.
• Press [MUTING] key
Memorize the data.
NOTE:
Setting for any of the following items that is not included in the
"ADJUSTMENT PROCEDURE" section found in the later part
of this manual will not be performed in servicing.
1-26 (No.YA089)
D01 F01
D01 F01
2. YC SEP (3D Y/C separation setting)
[Do not change settings of items that are not included in the
"ADJUSTMENT PROCEDURE" section. ]
Sets output data to the 3D Y/C separation circuit.
• Press [CH+] / [CH-] key
For scrolling up/down the item codes.
• Press [VOL+] / [VOL-] key
For scrolling up/down the data values.
3. WHITE BALANCE (White balance setting)
[Setting for this item is not required in servicing.]
4. MEMORY SETUP (Memory setting)
[Do not change settings]
5. RF AFC
Setting for this item is not required in servicing.
6. DD/CM
[Do not change settings]
Adjustment of color manegment and device driver
7. PANEL (Panel power limit control)
[Do not change settings]
8. PP (Multi-screen processing setting)
[Do not change settings of items that are not included in the
"ADJUSTMENT PROCEDURE" section.]
Sets output data to the multi-screen processing circuit.
• Press [CH+] / [CH-] key
For scrolling up/down the item codes.
• Press [VOL+] / [VOL-] key
For scrolling up/down the data values.
9. IP (DIST setting)
[Do not change settings]
Sets output data to the DIST circuit.
0. HDMI
[Do not change settings]
Sets output data to the DIGITAL INPUT circuit