Jumper Description; Connector Description - Supermicro X11SAT User Manual

Quick Reference Table
Jumper Description
JBT1 CMOS Clear
JI C1/JI C2 SMB to PCI-E Slots Enable/Disable
2 2
JPAC1 Audio Enable
JPB1 BMC Enable/Disable
JPG1 VGA Enable/Disable
JPL1/JPL2 LAN1/LAN2 Enable/Disable
JPME2 Manufacturing Mode
JPUSB1 USB0/1 Wake up
JWD1 Watch Dog
LED Description
LED1 Power LED
LED2 M.2 LED
LEDM1 BMC Heartbeat LED
Connector Description
AUDIO FP Front Panel Audio Header
B1 Onboard Battery
COM1 COM Header
DVI/VGA Digital Video Interface/VGA Connectors (VGA on X11SAT-F only)
FAN1 ~ FAN5 System/CPU Fan Headers (FAN1: CPU Fan)
HD Audio High Defintion Audio Connector
HDMI High Definition Multimedia Interface Connector
I-SATA0 ~ I-SATA5 Intel® PCH SATA 3.0 Ports
I-SGPIO1/I-SGPIO2 General Purpose I/O Headers
JD1 Speaker/Buzzer (Pins 1-4: Speaker, Pins 3-4: Buzzer)
JF1 Front Control Panel Header
JIPMB1 System Management Bus Header (for IPMI card)
JL1 Chassis Intrusion Header
JLED1 3-Pin Power LED Indicator Header
JOH1 Overheat LED Header
JPI C1 Power Supply SMBus I
2
JPW1 24-pin ATX Power Connector
JPW2 8-pin 12V Processor Power Connector
JSD1/JSD2 SATA DOM Power Connectors
JSPDIF_IN Sony/Phillips Digital Interconnect Format Audio In Header
JSPDIF_OUT Sony/Phillips Digital Interconnect Format Audio Output Header
JSTBY1 Standby Power Header
Note: Table is continued on the next page.
Status
Green: Power On
On: M.2 on board
Blinking Green: BMC Normal
C Header
2
13
Chapter 1: Introduction
Default Setting
Open (Normal)
Both Open (Disabled)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Normal)
Pins 1-2 (Enabled)
Pins 1-2 (Reset)