Philips HR1851 Directions For Use Manual page 7

2 Pull the mains cord out of the cord
storage compartment at the back of the
appliance.
C
3 Attach the spout to the juice collector by
snapping it into position.
C
4 Place the juice collector onto the
appliance and put the filter in the juice
collector. Make sure the filter is fitted
securely onto the driving shaft.
Always check the filter before use. If you detect
any cracks or damage, do not use the appliance
and contact the nearest Philips service centre or
take the appliance to your dealer.
C
5 Attach the pulp container to the appliance
by aligning the latch on the pulp container
with the slot on the motor unit and then
pushing the pulp container home. Hold the
lid over the filter and lower it into
position.
While you are preparing juice, you can empty the
pulp container by switching the appliance off and
carefully removing the pulp container.
Reassemble the empty pulp container before you
B
continue juicing.
C
6 Snap the two clamps onto the lid to lock it
into place ('click'). Slide the pusher into the
feeding tube.
Make sure the clamps are locked into position on
either side of the lid.
C
7 Place the juice jug under the spout.
The juice jug has a removable foam separator to
separate the foam from the juice when pouring
the juice into a glass.
Using the appliance
The appliance will only function if all parts have
been properly assembled and the lid has been
properly locked in place with the clamps.
Do not operate the juicer for more than
40 seconds at a time when juicing heavy loads
and let it cool down afterwards. None of the the
recipes in these instructions for use constitute
heavy loads.
1 Wash the fruit and/or vegetables and cut
them into pieces that fit into the feeding
tube.
2 Make sure the spout has been attached to
the juice collector and the juice jug has
been placed under the spout.
ENGLISH
7