Table of Contents
Advertisement
Using the HC700-G
Starting to Work
Place the battery in the HC700-G to boot-up and press the
Power Button (see Figure 1) to turn on the HC700-G; the
Motorola logo will show for about 30 seconds and Windows
Mobile screen will appear. The Windows Mobile screen will
instruct to tap on the screen and to follow the Align Screen
procedure (touch screen calibration).
Turning Off
Turn off the HC700-G when not in use for long duration and
when charging is not available.
Important: When the HC700-G is out of the cradle, do not
attempt to turn off the unit when the Status LED (inside the
Power button) shows red. Pressing the Power button when
the Status LED shows red (system initialization), may cause
damage to the operating system.
Turning off when the unit is on
If the unit is turned on (the screen is on), perform the
following:
Hold down the Power button for at least four seconds
until the screen turns off - the Status LED should be off.
The HC700-G will store the information of the last used
program screen and will turn off. No information will be
lost from the memory. Once turned on again, the HC700-
G will return to the last program screen that previously in
use.
Turning off when the unit is in Suspend mode
If the unit is in Suspend mode (the screen is off and the Sta-
tus LED flashes green), perform the following:
1. Resume operation by momentarily pressing the Power
button.
2. Wait for five seconds.
3. Hold down the Power button pressed for four seconds
until the screen turns off.
11
Advertisement
Table of Contents
