Roll Paper Cannot Be Inserted Into The Paper Feed Slot; Cannot Load Sheets; Paper Is Not Cut Straight; Paper Is Not Cut - Canon ipf8300 User Manual

Roll paper cannot be inserted into the paper feed slot

The roll paper is warped.
Paper is jammed by the paper feed slot.
The paper source selection is incorrect.

Cannot load sheets

The paper source selection is incorrect.

Paper is not cut straight

The paper is bent or curled at the cut position.
Paper rises by the ends of the cut position be-
fore it is cut.
You are using paper that cannot be cut with the
Cutter Unit.
The Cutter Unit is not installed correctly.
The Cutter Unit blade is worn out.
Cut Speed is not configured correctly in the
Control Panel menu.

Paper is not cut

In the printer driver, No or Print Cut
Guideline is specified in Auto Cut.
In the Control Panel menu, Cutting Mode
is set to Eject or Manual.
The Cutter Unit is not installed.
Rolls are not cut when you are using the
Media Take-up Unit.
iPF8300
Downloaded from ManualsPrinter.com Manuals
Cause
Straighten out curls and reload the roll.
Remove the jammed paper.
(See "Clearing Jammed Roll Paper.")
(See "Clearing a Jammed Sheet.")
Press the Load button and select the paper source.
Cause
Press the Load button and select the paper source.
Cause
Cause
Specify Yes in Auto Cut in the printer driver.
If the Cutting Mode is Eject, press the Cut button to cut the paper.
If the Cutting Mode is Manual, cut rolls with scissors or the like.
Install the Cutter Unit.
(See "Replacing the Cutter Unit.")
Either cut the roll paper by pressing the Cut button or lift the Release
Lever and cut the roll with scissors.
(See "Removing Printed Documents from the Media Take-up Unit
(Optional).")
Troubleshooting
Corrective Action
→P.1047
Corrective Action
Corrective Action
Straighten out any curling by the edges of the paper.
Reload the paper correctly.
Specify Manual in Cutting Mode in the Control Panel menu and
use scissors or a cutting tool to cut the roll after printing.
(See "Specifying the Cutting Method for Rolls.")
Reinstall the Cutter Unit correctly.
(See "Replacing the Cutter Unit.")
Replace the Cutter Unit.
(See "Replacing the Cutter Unit.")
Change the Cut Speed setting in the Control Panel menu.
(See "Menu Structure.")
→P.904
Corrective Action
→P.831
Roll paper cannot be inserted into the paper feed slot
> Problems Regarding Paper
→P.1043
→P.794
→P.1011
→P.1011
→P.1011
>
12
1051