Supero A1SAi-2550F User Manual page 77

Hex value of LBC45
Use this feature to select the hex value for LBC45. Use the keypad to enter a
value.
SATA Port 0/SATA Port 1
The submenu below allows the user to configure the following settings for SATA
Port 0 or SATA Port 1.
Spin Up
On an edge detect from 0 to 1, use this feature to set a COMRESET initialization
sequence for a device. The options are Enabled and Disabled.
Hot Plug
Set this item to Enabled for hot-plugging support, which will allow the user to re-
place a SATA drive without shutting down the system. The options are Enabled
and Disabled.
External Device
Select Enabled for external SATA device support. The options are Enabled and
Disabled.
Mechanical Switch
Select Enabled for mechanical switch support. The options are Enabled and Dis-
abled.
SATA 2 Controller
This feature allows the user to configure the settings of SATA 2.0 devices
Sata Controller
Select Enabled to enable the onboard SATA 2.0 controller on the motherboard. The
options are Disabled and Enabled.
Sata Mode
This item selects the mode for the installed SATA drives. The options are IDE and
AHCI.
LPM (Link Power Management)
Select Enabled to support Link Power Management to improve system power
management. The options are Disabled and Enabled.
Overwrite SIR Values
Select Enabled to overwrite SIR values. The options are Disabled and Enabled.
4-19
Chapter 4: AMI BIOS