Supero A1SAi-2550F User Manual page 69

Pass Gate Test Repetition
Use this feature to specify how many times the Pass Gate test should be per-
formed over the same memory row (x1000). The default setting is 900.
Pass Gate Test Iterations
Use this feature to specify how many repetitions the Pass Gate test should be
performed over the same memory row (refer to the item above). The default
setting is 1.
Pass Gate Test Swizzle (For Samsung Products)
Select Enabled to use the Pass Gate Test Swizzle mode to support Samsung
products. Select Auto for the system to automatically switch to the Pass Gate
Test Swizzle mode when a Samsung device is detected. The options are Auto
and Enabled.
Pass Gate Pattern
Use the keyboard to enter the parameter value of the Pass Gate Pattern used
for data input. The options are 0's and 1's.
Pass Gate Target Pattern
Use the keyboard to enter the target parameter value for the Pass Gate Pattern
used for data input. The options are 0's and 1's.
Pass Gate Speed
Use this feature to set the Pass Gate speed. The options are Auto and 1x Only.
Channel 0/Channel 1
Rank 0/Rank 1/Rank 2/Rank 3
Select Enabled to allow the Pass Gate test to be performed on a memory module
specified by the user. The options are Disabled and Enabled.
Pass Gate MonteCarlo
Select Enabled to enable a algorithm search to find the maximum value of the
Pass Gate test. The options are Disabled and Enabled.
If Pass Gate MonteCarlo is set to Enabled, the following three items are avail-
able for configuration:
Pass Gate Maximum Failures
Use this feature to specify the maximum number that Pass Gate failures will be
counted for. Use the keyboard to enter the desired value.
4-11
Chapter 4: AMI BIOS