Directly Accessing A Channel; Confirmation Tone(S) Function; Presetting A Desired Channel - Audiovox SRSIR-001 Owner's Manual

CHANNEL NUMBER
FLASHES
Figure 7. Accessing Channels
SELECTING CHANNEL CATEGORIES (only in Category Mode)
This section describes the procedure used to select a specific group or
category of entertainment. Entering into category mode can be accom-
plished either by Pressing (SFT)+0981+(SFT) or to quickly shift between
Category mode and Channel mode, momentarily Press and release
(SFT) then Press and Hold (SFT) for 2 seconds, "ENTER CATEGORY
TUNE" or "ENTER CHANNEL TUNE" will be displayed .
1. With the system powered up, momentarily press the Shift (SFT)
button causing the first channel number in the current category
to flash for 5 seconds.
2. While the number is flashing, momentarily press and release
either directional button (
The category will advance one at a time and will also flash for 5
seconds. If no further advance is made, the flashing will stop
and the category will then remain steady.
3. To advance rapidly in the chosen direction (Up or Down) and
while the channel number is flashing, momentarily press and
release either directional button (
lease the directional button when a desired channel is reached.
C A T E G O R Y / C A T E G O R Y /
GROUP
GROUP NUMBER
FLASHES
Figure 8. Selecting Channel Categories
PRESS KEYPAD BUTTONS
TO SELECT DESIRED
CHANNEL
PRESS THE SHIFT
BUTTON
) a desired category is reached.
) in a rapid manner. Re-
PRESS UP BUTTON TO
ADVANCE TO NEXT
HIGHER CATEGORY
PRESS
PRESS DOWN BUTTON TO
SHIFT
ADVANCE TO NEXT
LOWER CATEGORY
The channel tuning will automatically wrap around from the last to the first
channel in that category or vice-versa. When a new category is chosen, the
radio will automatically select the first channel in that category.
NOTE: If a directional button is Pressed and Held channels will begin to scroll
in numerical sequence through all categories until the button is released.
This navigation mode will continue to function in the same manner in the new
category. The user must exit this mode before attempting to perform any other
function. To exit this mode, enter Shift (SFT) 0980 Shift (SFT).
PRESETTING DESIRED CHANNELS
This section describes how to preset up to 20 channels on your SCU
(two groups of 10 channels, upper and lower) for rapid and easy access.
Proceed as follows:
1. Select the desired channel you wish to save in memory by using the
directional buttons ( ), direct access method, or category select tuning
method.
2. With the desired channel displayed, press and hold any one of the numbered
keypad buttons until the confirmation tone (or second tone) is heard
(Refer to Confirmation Tone(s) Function). Continue with this process until
the first group of 10 preset channels is loaded (lower group).
NOTE: There is a preset channel group indicator icon located in the top right
corner of the SCU display. This is used
· ( ) = Lower Preset Channel Group (first 10 channels)
SR1
· ( ) = Upper Preset Channel Group (next 10 channels)
SR2
3. Repeat the procedure in steps 1 and 2 to save nine other desirable channels
for quick access.
CH 4
THE PRESET MEMORY LOCA-
SELECT THE
TION APPEARS HERE
DESIRED CHANNEL
Figure 9. Setting Preset Channels
7
to determine which group you are in.
PRESS AND HOLD
ANY NUMBER BUTTON
(0-9) TO COMMIT THE
CHANNEL TO PRESET
MEMORY
128-6374A
7 of 12