Using The Up/Down Buttons; Selecting Channel Categories Or Groups - Audiovox SRSIR-001 Owner's Manual

A typical channel display will appear as shown below.
CHANNEL
NAME
ARTIST
NAME
SONG TITLE
CHANNEL
NUMBER
CATEGORY (only in Category Mode)
Figure 5. Sample SIRIUS ® Display

USING THE UP/DOWN BUTTONS

This section describes two ways the Down ( ) and Up ( ) directional
buttons are used to select an SIRIUS® channel. Proceed as follows:
1. To advance one channel at a time in the chosen direction (Up or
Down), momentarily press and release either directional
button ( ) until a desired channel is reached.
2. To advance rapidly in the chosen direction (Up or Down), press
and hold either directional button (
button when a desired channel is reached.
MOMENTARY PRESS:
ADVANCE DOWNWARD
ONE CHANNEL AT A
TIME
PRESS AND HOLD:
CONTINUOUS ADVANCE
DOWNWARD
Figure 6. Using the UP / Down Buttons
NOTE: When an invalid (no broadcast) channel is encountered, the
channel is automatically skipped.
Confirmation Tone(s) Function
There are two basic functions of this feature; the Command Confirmation
PRESET GROUP INDICATOR
Tone, the Station Pre-Set Program Confirmation Tones. The following is
SR1 -or - SR2
a description of each of these functions:
PRESET CHANNEL
DIRECTLY ACCESSING A CHANNEL
) . Release the directional
This section describes the procedure used to directly access a specific
channel, this is different then making direct access in Category mode
(see SELECTING CHANNEL CATEGORIES)
MOMENTARY PRESS:
ADVANCE UPWARD ONE
CHANNEL AT A TIME
PRESS AND HOLD:
CONTINUOUS ADVANCE
UPWARD
NOTE: If the selected channel is not available within the band, a "In-
valid Channel" message will appear on the display and the system will
remain tuned to the previous channel.
6
1. Command Confirmation Tone - This function utilizes a single
High Tone signal that is heard each time a button is pressed to
confirm that the command was executed. This tone is imple-
mented each time the user presses the Power, Mute, Scan,
Shift or Directional ( ) button(s) as well as for each of the
numbered buttons.
2. Station Pre-Set Program Confirmation Tones - This function
utilizes two High Tone signals that are heard each time the user
programs a Pre-Set channel. When the user enters a channel
into memory (Refer to Presetting A Desired Channel below) a
High Tone will be heard as the selected number button is
pressed and held. A second High Tone Signal is heard con-
firming that the Pre-Set command was executed. It is only after
the second tone that the user can release the button (approxi-
mately two seconds).
1. With the system powered up, momentarily press the Shift (SFT)
button causing the first channel number in the current category to
flash for 5 seconds. The flashing number indicates the Channel
number in Channel mode.
2. While the number is flashing, use the number buttons on the
keypad to enter the channel desired. The selected channel
number will flash for 5 seconds and then remain steady.
The flashing number indicates the value of the Category in
Category mode.
128-6374A
6 of 12