Operation - Delta SMT150LED User Manual

OPERATION

SMT130H SMT130M
control options control options
Single Models: SMT130, SMT150, SMT150LED
1. Single speed control mode: Turn the POWER switch
on to operate at single speed mode - the LED
indicator will be green.
2. Turn the POWER switch on/off to operate the fan /
LED light / LED night light.
Humidity Model: SMT130H
3. Humidity control mode: Turn the POWER switch
on to operate at humidity control mode - the LED
indicator will be blue. When the ambient humidity
is higher than the user-adjustable set-point, the fan
will run at full speed. When the ambient humidity is
lower than the set-point, the fan will continue to run
at the full speed until a 10-minute time delay has
elapsed, and then will automatically change to the
user-adjustable low speed airflow.
4. Full speed mode: Turn the MODE switch on to
operate at full speed mode - the LED indicator will
be amber.
Model: SMT130/SMT130H/SMT130M/SMT150/SMT150D/
SMT150LED
Delay time control
(SMT130M & SMT150D)
or Humidity preset control
(SMT130H).
Low speed air volume
preset control (SMT130H,
SMT130M, SMT150D).
SMT150D
control options
8
Factory setting: low speed airflow 70CFM, humidity
60%RH.
Note: Humidity tolerance is about ±10%.
Motion Model: SMT130M
5. Motion control mode: Turn the POWER switch on
to operate at motion control mode. When motion is
detected, the fan will run at full speed mode - the
LED indicator will be amber. When motion is not
detected, the fan will continue to run at the full speed
until the user-adjustable time delay has elapsed, and
then will automatically change to the user-adjustable
low speed airflow - the LED indicator will be green.
6. Motion sensor detectible
range: The distance that
motion can be detected
is limited to 10 feet (3m).
The field of view of the
sensor is 90°. (Room
temperature is 25°C)
Factory setting: low speed airflow 70CFM, time delay
15 minutes.
Dual Speed Model: SMT150D
7. Low speed control mode: Turn the POWER switch
on (MODE switch is off) to operate at the user-
adjustable low speed airflow - the LED will be green.
8. Full speed control mode: Turn the POWER switch &
MODE switch on to operate at full speed mode - the
LED indicator will be amber. When the user turns the
MODE switch off, the fan will continue to run at the
full speed until the user-adjustable time delay has
elapsed, and then will automatically change to the
user-adjustable low speed airflow - the LED indicator
will be green.
Factory setting: low speed airflow 70CFM, time delay
15 minutes.
Sensor
90°