Assembly Instructions - Delta SMT150LED User Manual

ASSEMBLY INSTRUCTIONS

Attach duct connector
1. Attach the duct connector from outside, and secure
by using one screw (#8-32x1/4").
Hardware
Screw
B
2. Remove the motor assembly, attach the duct
connector from the housing can inside, and secure
by using one screw (#8-32x1/4"). Insert and secure
motor assembly.
Hardware
Screw
B
Note: Remove the tape from the damper before installation.
Install the housing (I)-using suspension brackets
1.  S liding suspension brackets are available to allow
for positioning of the housing anywhere between
joists up to a span of 24".
2. Insert the suspension brackets into the channels on
the housing. Make sure the tabs face up as shown.
(Fig. C).
3. Extend the suspension brackets to fit the width
of the joists. Hold the fan in place by wrapping
the suspension bracket tabs around the bottom
of the joist. Make sure the fan body is level and
perpendicular to the joist. (Fig. D).
1
Insert tab into hole in housing Insert tab into the gap between
❶
fan unit and housing
2
❶
Pull existing ductwork
into Housing
C
Suspension Bracket
❹
D
Screw
Joist
5
Model: SMT130/SMT130H/SMT130M/SMT150/SMT150D/
SMT150LED
❷
Screw from Parts Bag
❸ ❷
Screw from
Insert tab into hole in
Parts Bag housing
Tab Face
Channel
Joist
Bottom of Joist