VENTILATION FAN MODEL SMT130/SMT130H/SMT130M/SMT150/SMT150D/SMT150LED TABLE OF CONTENTS Package Contents General Safety Information Preparation and Wiring Diagrams Assembly Instructions Grille Installation Operation Care and Maintenance Troubleshooting Dimensions Product Specifications Warranty READ AND SAVE THESE INSTRUCTIONS Address: 46101 Fremont Boulevard, Fremont, CA 94538 US Toll Free Number: 1-888-979-9889 www.deltabreez.com...
When cutting or drilling into the wall or ceiling, do not damage electrical wiring and other hidden utilities. Cooking floor Equipment Ducted fans must always be vented to the outdoors. If this unit is to be installed over a tub or shower, it must Fig. B Model: SMT130/SMT130H/SMT130M/SMT150/SMT150D/ SMT150LED...
2. NEVER place a switch where it can be reached BLACK from a tub or shower. WHITE POWER SWITCH 3. Connect wires as shown in wiring diagrams. GREEN LED Light Model: SMT150LED BLACK JUNCTION BOX SWITCH BOX WHITE GROUND BLACK...
Hold the fan in place by wrapping the suspension bracket tabs around the bottom of the joist. Make sure the fan body is level and perpendicular to the joist. (Fig. D). Joist Joist Bottom of Joist Model: SMT130/SMT130H/SMT130M/SMT150/SMT150D/ SMT150LED...
Page 6
1. Insert the 6” duct (not provided) into the duct connector and tape all ductwork connections to Gradient Ceiling make them secure and airtight. (Fig. H). 1°~2° Duct connector 2. Install the duct with a gradient 1°~2° to the outside. Model: SMT130/SMT130H/SMT130M/SMT150/SMT150D/ SMT150LED...
1. Insert the motion sensor unit into the grille. (Fig. I). Celling (only SMT130M) Celling Celling Insert the LED light connector into the LED socket. Celling (Fig I). (only SMT150LED) 2. With the power on, check for abnormal vibrations or Sensor unit Sensor unit LED light connector Grille sounds.
- the LED indicator will be green. Single Models: SMT130, SMT150, SMT150LED 6. Motion sensor detectible range: The distance that 1. Single speed control mode: Turn the POWER switch...
3. Do not soak resin parts in water over 140°F (60°C). CLEANING 1. Pull down the springs (and power connects of the LED light engine if SMT150LED) to remove the grille. 2. Wash and clean the grille. CAUTION: Do not let water into the LED light engine. (Use non-abrasive kitchen detergent and wipe dry with a new cloth.)
The fan is not able to draw air out of the room without enough airflow to draw in from. 2. Insufficient CFM 2. Be sure the CFM rating on the fan matches the requirements for your room size. Model: SMT130/SMT130H/SMT130M/SMT150/SMT150D/ SMT150LED...
6. To qualify for warranty service, you must notify Delta Electronics at the address or telephone number below. 7. Delta Electronics shall have no liability to the original owner-user with respect to any defect caused by abuse, misuse, neglect, improper transportation or storage, improper testing, improper installation, improper operation,...