CrimeStopper SP-102 Owner's Manual page 5

SYSTEM COMMANDS
Ignition Controlled Door Locks - If this feature is enabled in the programming, the doors will automatically lock when the ignition is
turned ON and will unlock when the ignition is turned OFF. This feature can be turned ON or OFF in the programming.
Trunk Release - To release the trunk (if this options is applicable and installed), press Button #4 (TRUNK) on the remote for at least
4 seconds. If "disarm with trunk release" has been disabled, the trunk WILL open without activating the alarm when using the remote
only, but the system will remain armed.
Alarm Triggering - If there is an intrusion into the vehicle or a hard impact to the body, the alarm will sound and flash the parking
lights for 45 seconds. After 45 seconds the siren and the flashing parking lights will stop; the alarm will remain armed and continue to
monitor the vehicle. If an intruder left the door open, the unit will cycle a second time of 45 seconds and then continue to monitor the
remaining un-tampered zones of the vehicle.
Panic/Vehicle Finder - To sound the alarm with the remote, press and hold Button #1 (LOCK) for at least 3 seconds or until the siren
sounds. To shut off the remote panic, press Button #1 (LOCK) and the alarm will reset.
VALET MODE
Valet Operation – This will disable the alarm system while still allowing the keyless entry portion to still work (if applicable).
Entering Valet Mode – Turn the ignition to the ON position. Press and hold the Override/Program button for 4-5 seconds until the alarm
LED turns ON solid and the system chirps the siren once.
Exiting Valet Mode – Turn the ignition to the ON position. Press and hold the Override/Program button for 4-5 seconds until the alarm
LED turns OFF and the system chirps the siren twice.
5