Maintenance
6.1
Replacing the fuse
Introduction
The terminal block is equipped with replaceable fuses.
The figure below shows the fuses in the terminal block.
Figure 6-1
Requirements
Switch off the supply voltage before you replace any fuses. Result: Station failure of the ET
200eco PN.
Replacing a fuse of the terminal block
1. Remove the screws from the front panel of the terminal block using a crosstip
2. Remove the top section.
3. Remove the faulty fuse.
4. Press the new fuse (miniature copper flat fuse, type FK1, 7.5 A, fast-blow) into the fuse
5. Connect the terminal block and tighten the screws.
6. Switch on the supply voltage again.
ET 200eco PN
Operating Instructions, 06/2009, A5E01250250-04
Fuses in the terminal block
screwdriver.
holder. The fuse is available as accessory.
6
71