Name Plate; Transport Safety Instructions; Storage Conditions - ABB PositionMaster EDP300 Operating Instruction

Change from two to one column
1.6

Name plate

Fig. 1: Name plate (sample)
1 Full type designation | 2 Order code | 3 Serial number
6 Hardware revision / software revision | 7 Date of manufacture | 8 Explosion protection | 9 Manufacturer | 10 Supply air pressure |
11 Input signal | 12 Ambient temperature range | 13 Output | 14 Safety function (no current) | 15 Communication protocol |
16 Degree of protection | 17 Options
Change from one to two columns
1.7

Transport safety instructions

Observe the following instructions:
— Do not expose the device to moisture during transport.
Pack the device accordingly.
— Pack the device so that it is protected against vibrations
during transport, e.g., by using air-cushioned packaging.
| 4 Special version | 5 Year of manufacture |
1.8

Storage conditions

— The device must be stored in dry and dust-free conditions.
The device is also protected by a desiccant in the
packaging.
— The desiccant guarantees sufficient protection for
approximately 150 days. It can be regenerated at a
temperature of 90 °C (114 °F) within 4 h.
— Remove the desiccant prior to commissioning the actuator
or the electronics.
— If you intend to store or transport the device for a
prolonged period (> 6 months), we recommend that you
wrap it in plastic film and add desiccant.
— The permissible storage and transport temperatures must
be observed.
— Protect uncovered metallic surfaces with an appropriate
long-term corrosion inhibitor.
— The relevant long-term storage temperatures must be
observed.
— In principle, the devices may be stored for an unlimited
period. However, the warranty conditions stipulated in the
order confirmation of the supplier apply.
PositionMaster EDP300 | OI/EDP300-EN 7