Menu: Device Setup - ABB PositionMaster EDP300 Operating Instruction

8.4.2

Menu: Device Setup

... / Device Setup
Menu / Parameter Value range
Actuator Type Linear, Rotary
Vent Position Position 0%,
Position 100%
SETPOINT SP Range Min.
SP Range Max.
SP Filter
SP Ramp Up
SP Ramp Down
SP Charact. Curve
SP Direction
RANGE SETTINGS VALVE RNG CALIB.
Upper Working Rng
Lower Working Rng
END STOP BEHAVE Tight Shut 0%
Control at 0%
Dead Angle 0%
Tight Shut 100%
Control at 100%
Dead Angle 100%
Recalc. Position Off
On
Description
Use this parameter to configure the configuration-, parameterization instruction for the positioner
for operation on a linear actuator (sensor range +/-30°) or on a part-turn actuator (sensor
range +/-45°). No mechanical modifications to the positioner are required.
The linearization can be selected under the "Linear" parameter in accordance with the mounting
conditions:
IMPORTANT (NOTE)
After changing the actuator type, it is recommended that you run Autoadjust to
prevent linearity errors.
Use this parameter to specify which position is to be shown in the display when output 1 of the
positioner is completely vented.
The parameters for the setpoint are set in this parameter group.
The valve end positions and the working range in which the valve is to be controlled are set in this
parameter group.
The end position behavior is set in this parameter group.
Use this parameter to define whether the position indicator and analog position feedback display
the valve position (Direct) or the valve flow (Recalculated).
PositionMaster EDP300 | OI/EDP300-EN 33