D-Link DCS-7110 User Manual page 45

Configuration
Filter Type
Select Allow or Deny as the filter type. If you choose Allow, only those clients
whose IP addresses are on the Access List below can access the camera, and all
others cannot access. If you choose Deny, those clients whose IP addresses
are on the Access List below will not be allowed to access the camera, and all
others can access.
Filter
You can add a rule to the Access List.
Note that the IPv6 access list column will not be displayed unless you enable
IPv6 on the Network page. Refer to "IPv6" on page 37 for more information.
There are three types of rules:
• Single: This rule allows the user to add an IP address to the Allow/
Deny list.
• Network: This rule allows the user to assign a network address and
corresponding subnet mask to the Allow/Deny list.
• Range: This rule allows the user to assign a range of IP addresses to
the Allow/Deny list (This rule is only applied to IPv4).
Administrator IP address
Always allow the IP address to access this device: You can select this item and
add the Administrator's IP address in this field to make sure the Administrator
can always connect to the device.
D-Link DCS-7110 User Manual 45