Dlp-L48 Installing The Dc Power Module In The Ncs 2002 Shelf - Cisco NCS 2006 Hardware Installation Manual

Installing the Cisco NCS 2002 Door and Other Modules
Step 2 Plug the AC power module completely into the chassis.
Step 3
Tighten the screw to a torque value of 4 in-lb (0.45 N-m) to lock the power module in the chassis (see the
figure below).
Figure 76: AC Power Module Installed in the NCS 2002 Shelf
Step 4 Return to your originating procedure.

DLP-L48 Installing the DC Power Module in the NCS 2002 Shelf

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
DLP-L48 Installing the DC Power Module in the NCS 2002 Shelf
This task installs the DC power module in the NCS
2002 system.
#2 Phillips Dynamometric screwdriver
• Connect the chassis to the office ground. For
detailed instructions on how to ground the
chassis, refer to the
Grounding Guide for Cisco NCS 2000 Series
Required
Onsite
None
Cisco NCS 2000 Series Hardware Installation Guide
Electrostatic Discharge and
.
129