Convenient Shooting Functions; Scan Reverse Shooting; Displaying The Zebra Pattern; Displaying The Center Marker - Panasonic AK-UB300G Operating Instructions Manual

Convenient shooting functions

Scan reverse shooting

Image can be displayed reversed vertically or horizontally by setting [MAIN MENU] → [SYSTEM MODE] → [SCAN REVERSE].

Displaying the zebra pattern

The camera can display two types of zebra patterns.
The zebra pattern set by the menu is displayed by setting [MAIN MENU] → [DISPLAY SETUP] → [MARKER] → [ZEBRA] → [ON].
The level for zebra pattern display can be set in [MAIN MENU] → [DISPLAY SETUP] → [MARKER] → [ZEBRA].
Item
[ZEBRA1 LEVEL]
[ZEBRA2 LEVEL]
[ZEBRA PATTERN]
[SPOT]: The image level from the setting value of [ZEBRA1 LEVEL] to the setting value of [ZEBRA2 LEVEL] is displayed in the zebra pattern.

Displaying the center marker

Displays when set to [MAIN MENU] → [DISPLAY SETUP] → [MARKER] → [CENTER MARK] → [ON].

Displaying the safety zone marker

The one selected in [MAIN MENU] → [DISPLAY SETUP] → [MARKER] → [SAFETY MARK] is displayed.
The size of the safety zone marker can be changed in [MAIN MENU] → [DISPLAY SETUP] → [MARKER] → [SAFETY AREA].

Displaying the frame marker

Displays when set to [MAIN MENU] → [DISPLAY SETUP] → [MARKER] → [FRAME MARK SWITCH] → [ON].
Sets the angle of view in [MAIN MENU] → [DISPLAY SETUP] → [MARKER] → [FRAME SIG].
Sets the outside level in [MAIN MENU] → [DISPLAY SETUP] → [MARKER] → [FRAME MARK SWITCH] → [FRAME LEVEL].

Dynamic range stretcher function

You can increase the dynamic range by compressing the image signal for the extremely bright areas that are overexposed during normal shooting while
maintaining contrast.
The knee function or the black gamma function will not operate when the dynamic range stretcher function is enabled.
A slight difference in coloring might occur by switching the dynamic range stretcher function enable/disable.
The level of compression can be change in [MAIN MENU] → [PAINT] → [DRS] → [EFFECT DEPTH].
Chapter 3 Operation — Convenient shooting functions
Sets the extraction level of zebra pattern 1.
[0%] - [109%]
f Factory setting: [80%]
Sets the extraction level of zebra pattern 2.
[0%] - [109%]
f Factory setting: [100%]
Selects the type of the zebra pattern.
[1], [1+2], [SPOT]
f Factory setting: [1]
Image level
[ON]
[109%]
[ZEBRA2 LEVEL]
[ZEBRA1 LEVEL]
[0%]
Description of settings
[OFF] [SPOT]
– 36 –