Mitsubishi FREQROL-SFJ Maintenance Manual page 42

3.8.6 ,Adjustment of oriented spindle stop function
Adjustment
Since there is no control means (potentiometer or ro-
tary switch) for stop position adjustment, stop posi-
tion should be adjusted by changing parameter setting
as described below.
Press @ or @ switch to adjust stop position.
The spindle remains rotating while switch is held
down.
100 of data value (one revolution for 4096 of data
value).
dial gauge or other measuring device and press m
switch.
After the completion of stop position adjustment,
turn off and on the power or press RESET switch to
reset.
bus line, the values set for parameters "27" and
0RS2 appearing on the NC display screen ("Spindle
parameter", page 2).
procedure
dle stop function)
0
switch.
SET
The spindle rotates about 1 deg. for each