Lexus LX570 Manual page 304

2-5. Driving information
● Disconnecting a trailer
Put the 4-Wheel AHC in the "LO" (low) mode. (Make sure the
STEP 1
vehicle height is in the "LO" mode by pulling the switch to "" on
the height select switch.)
Turn off the "ENGINE START STOP" switch or the 4-Wheel
STEP 2
AHC.
Set the supporting leg of a trailer on the ground and raise the
STEP 3
hitch by 4 in. (100 mm).
Turn on the "ENGINE START STOP" switch or the 4-Wheel
STEP 4
AHC.
Wait for about 20 seconds until the rear vehicle height is lowered
STEP 5
by the automatic leveling function.
Make sure the hitch is disconnected. If not, raise the hitch higher
STEP 6
and repeat steps 2 through 5.
Move the vehicle forward in the "LO" mode where the hitch does
STEP 7
not touch anything in the "N" (normal) mode.
Put the 4-Wheel AHC in the "N" mode.
STEP 8
304
LX570_U (OM60F86U)