LG fh695bdh6n Owner's Manual page 15

3
Push the adapter onto the end of the tap so that
the rubber seal forms a watertight connection.
Tighten the four fixing screws and the adapter
ring plate.
4
Pull the connector latch plate down, push the
supply hose onto the adapter, and release the
connector latch plate. Make sure the adapter
locks into place.
Latch plate
NOTE
• After connecting the supply hose to the water
tap, turn on the water tap to flush out foreign
substances (dirt, sand, sawdust, and etc.) in the
water lines. Let the water drain into a bucket, and
check the water temperature.
Connecting Hose to Appliance
Attach the hot water line to the hot water inlet on the
back of the washer. Attach the cold water line to the
cold water inlet on the back of the washer.
Cold water supply
NOTE
• After completing connection, if water leaks from
the hose, repeat the same steps. Use the most
conventional type of tap for the water supply. In
case the tap is square or too big, remove the guide
plate before inserting the tap into the adaptor.
Using the Horizontal Tap
Horizontal tap
Extension tap
Square tap
EN
Hot water supply
15