Installation Place Requirements - LG fh695bdh6n Owner's Manual

Hide thumbs Also See for fh695bdh6n:
Table of Contents

Advertisement

Available languages

Available languages

Installation Place Requirements

Location
30-50 cm
Level floor : Allowable slope under the entire
appliance is 1°.
Power outlet : Must be within 1.5 meters of either
side of the location of the appliance.
• Do not overload the outlet with more than one
appliance.
Additional Clearance : For the wall, 10 cm: rear/2
cm: right & left side
• Do not place or store laundry products on top of the
appliance at any time.
• These products may damage the finish or controls.
WARNING
• The plug must be plugged into an appropriate
outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
Positioning
• Install the appliance on a flat hard floor.
• Make sure that air circulation around the appliance
is not impeded by carpets, rugs, etc.
• Never try to correct any unevenness in the floor
with pieces of wood, cardboard or similar materials
under the appliance.
10
2 cm
2 cm
10 cm
2 cm
2 cm
• If it is impossible to avoid positioning the appliance
next to a gas cooker or coal burning stove, an
insulation (85x60 cm) covered with aluminum foil
on the side facing the cooker or stove must be
inserted between the two appliances.
• Do not install the appliance in rooms where
freezing temperatures may occur. Frozen hoses
may burst under pressure. The reliability of
the electronic control unit may be impaired at
temperatures below freezing point.
• Ensure that when the appliance is installed, it is
easily accessible for an engineer in the event of a
breakdown.
• With the appliance installed, adjust all four feet
using a transit bolt spanner to ensure the appliance
is stable, and a clearance of approximately 20 mm
is left between the top of the appliance and the
underside of any work-top.
• If the appliance is delivered in winter and
temperatures are below freezing, place the
appliance at room temperature for a few hours
before putting it into operation.
WARNING
• This equipment is not designed for maritime use
or for use in mobile installations such as caravans,
aircraft etc.
Electrical Connection
• Do not use an extension cord or double adapter.
• Always unplug the appliance and turn off the water
supply after use.
• Connect the appliance to an earthed socket in
accordance with current wiring regulations.
• The appliance must be positioned so that the plug
is easily accessible.
• Repairs to the appliance must only be carried out
by qualified personnel. Repairs carried out by
inexperienced persons may cause injury or serious
malfunctioning. Contact your local service centre.
EN

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents