Unpacking And Removing Transit Bolts - LG fh695bdh6n Owner's Manual

Unpacking and Removing
Transit Bolts
1
Lift the appliance off the foam base.
• After removing the carton and shipping
material, lift the appliance off the foam base.
Make sure the tub support comes off with the
base and is not stuck to the bottom of the
appliance.
• If you must lay the appliance down to remove
the carton base, always protect the side of the
appliance and lay it carefully on its side. Do
not lay the appliance on its front or back.
Tub Support
(Optional)
2
Remove the bolt assemblies.
• Starting with the bottom two transit bolts,
use the spanner (included) to fully loosen all
transit bolts by turning them counterclockwise.
Remove the bolt assemblies by wiggling them
slightly while pulling them out.
Transit
bolt
Carton base
Retainer
3
Install the hole caps.
• Locate the hole caps included in the
accessory pack and install them in the
shipping bolt holes.
Cap
NOTE
• Save the bolt assemblies for future use. To prevent
damage to internal components, Do not transport
the washing machine without reinstalling the transit
bolts.
• Failure to remove transit bolts and retainers may
cause severe vibration and noise, which can lead
to permanent damage to the washing machine. The
cord is secured to the back of the washing machine
with a shipping bolt to help prevent operation with
transit bolts in place.
EN
11