Initial Settings; G General Operation; G Language; G Display - Philips DVP 3055V Owner's Manual

Before Operation (Continued) - DVD part

Initial Settings

You can set your own Personal Preferences on the
player.
To display and exit the Menu:
Press SYSTEM MENU to display the menu. Press
SYSTEM MENU again to return to the initial screen.
To go to the next level:
Press 2 on the remote control.
To go back to the previous level:
Press 1 on the remote control.
General Operation
1
Press SYSTEM MENU.
The setup menu appears.
2
Use 3/4 to select the desired option then press 2 to
move to the second level.
The screen will show the current setting for the selected
option, as well as alternate setting(s).
3 Use 3/4 to select the second desired option then press
2 to move to the third level.
4 Use 3/4 to select the desired setting then press OK to
confirm your selection.
Some items require additional steps.
5
Press SYSTEM MENU or PLAY B to exit the setup
menu.
LANGUAGE
LANGUAGE
Menu Language
Disc Audio
Disc Subtitle
Disc Menu
Menu Language
Select a language for the setup menu and on-screen
display.
Disc Audio / Subtitle / Menu
Select a language you prefer for the audio track (disc
audio), subtitles, and the disc menu.
Original :The original language set for the disc is
selected.
Other :To select another language, press number buttons
to enter the corresponding 4-digit number according to
the language code list on page 35. If you enter the wrong
language code, press CLEAR.
DISPLAY
DISPLAY
TV Aspect
Display Mode
Progressive Scan
Video Output
18
English
Original
Off
Original
Move Select
DVD
16 : 9
Widescreen
Off
RGB
Move Select
DVD
TV Aspect
4:3 : Select when a standard 4:3 TV is connected.
16:9 : Select when a 16:9 wide TV is connected.
DVD
Display Mode
Display Mode settings is only available when the TV Aspect
mode is set to "4:3".
Letterbox: Displays a wide picture with bands on the
upper and lower portions of the screen.
Panscan: Automatically displays the wide picture on the
entire screen and cuts off the portions that do not fit.
Progressive Scan
Progressive Scan Video provides the highest quality
pictures with less flickering. If you are using the
Component Video jacks for connection to a TV or
monitor that is compatible with a progressive scan signal,
set Progressive Scan to On.
To turn on progressive scan:
Connect component out of this unit to the input of your
monitor/television, set your television or monitor to
component Input.
1
Select "Progressive Scan" on the "DISPLAY" menu then
press 2.
DISPLAY
TV Aspect
Display Mode
Progressive Scan
Video Output
2
Select "On" using the 3 / 4 buttons.
3 Press OK to confirm your selection.The confirm menu
will appear.
4 When the confirm menu appears on your screen
"Cancel" is highlighted as default. Use the 1 button to
highlight "Enter".
5
Press OK to set to progressive scan mode.
Caution
If you set Progressive Scan to On in error, you must reset
the unit.
1
Press and hold STOP for five seconds.
The video output will be restored to the standard setting
and a picture appear again on TV screen.
2
Do not turn off this unit while the "PROGRESSIVE SCAN
MODE" message is displayed on the TV screen.
Video Output
Set this unit's Video Output options according to the TV
connection type.
YPbPr:When your TV is connected with the
COMPONENT/PROGRESSIVE SCAN VIDEO OUT jacks
on this unit.
RGB:When your TV is connected with the SCART (RGB
signal) jack.
On
Off
Prev. Move OK Enter